ccna-commands

Card Set Information

Author:
gunbustr
ID:
121984
Filename:
ccna-commands
Updated:
2011-12-10 02:47:58
Tags:
ccna
Folders:

Description:
Useful CCNA commands
Show Answers:

Home > Flashcards > Print Preview

The flashcards below were created by user gunbustr on FreezingBlue Flashcards. What would you like to do?


  1. What is the command to display the MAC addresses on a switch?
    show mac-address-table
  2. What command is used to show information about neighboring switches on Cisco devices?
    show cdp neighbors
  3. What command is used to show the routing table?
    show ip route
  4. What command displays a summary of the interfaces?
    show ip interface brief
  5. What is the command to configure a static route?
    ip route <ip> <mask> <next hop | interface>
  6. What command is used to show the current configuration?
    show running-config
  7. What command is used to show the mapping of IP addresses to MAC addresses?
    show ip arp
  8. What command shows the version of the Cisco switch?
    show version
  9. What commands shows information about VLANs?
    • show vlan
    • show interface vlan
  10. What commands show information about the VLAN Trunking Protocol?
    • show vtp status
    • show vtp status brief
  11. How do you configure the RIP process?
    • router rip
    • network <IP_network_#>
    • version 1|2
  12. How do you configure IGRP?
    • router igrp <autonomous_system_#>
    • network <IP_network_#>
  13. How do you configure the OSFP process?
    • router ospf <process_ID>
    • network <IP_address> <wildcard> area <area_#>
  14. How do you configure EIGRP?
    • router eigrp <autonomous_system_#>
    • network <IP_network_#>
  15. How do you configure Frame Relay?
    • interface serial <[slot_#]/port_#>
    • encapsulation frame-relay [cisco|ietf]
    • frame-relay lmi-type ansi|cisco|q933a
  16. What command is used to show information about the spanning tree protocol?
    show spanning-tree

What would you like to do?

Home > Flashcards > Print Preview