Communication

Card Set Information

Author:
bidemi12
ID:
147571
Filename:
Communication
Updated:
2012-04-14 11:21:24
Tags:
Board study guide
Folders:

Description:
Communication
Show Answers:

Home > Flashcards > Print Preview

The flashcards below were created by user bidemi12 on FreezingBlue Flashcards. What would you like to do?


  1. What does SOI stand for?
    Signal Operation Instructions
  2. What does the SOI provide?
    • The organization of stations into nets
    • Assigns call signs
    • Designates
    • Net Control Stations (NCS)
    • Assigns frequencies
    • Security Procedures to be used by Radio Operators
  3. What Field Manual covers Tactical Single-Channel Radio Communications Techniques?
    FM 24-18
  4. What percent of slack should you allow when laying WD1 wire?
    20 percent
  5. Which means of communication is least secure?
    Radio
  6. What are five methods of communication?
    • 1. Radio
    • 2. Sound
    • 3. Visual
    • 4. Messenger
    • 5. Wire
  7. Which means of communication is most secure?
    Messenger
  8. What is COMSEC?
    COMmunications SECurity
  9. What is OPSEC?
    OPerations SECurity
  10. List 5 factors that affect the range of radio equipment?
    • Weather
    • Terrain
    • Antenna
    • Power
    • Location
  11. What does NCS stand for?
    Net Control Station
  12. What does MIJI stand for?
    Meaconing, Intrusion, Jamming and Interference
  13. What is the range of a TA-1 field phone?
    Approximately 3.7 miles using field wire
  14. How many volts are in a TA-1 field phone when squeezed?
    100 volts
  15. What is the maximum effective distance of a TA-312 field phone in wet and dry climates?
    • Wet - 14 miles
    • Dry -22 miles
  16. What does CB, LB, and CBS stand for on a TA-312 field phone?
    • CB-common battery
    • LB-local battery
    • CBS- common battery signaling
  17. BA30 batteries should be installed how, in a TA-312 field phone?
    1 up 1 down
  18. What is WD-1?
    Communications field wire
  19. What does the "W" and "D" stand for in "WD-1" Wire?
    Wire Drum
  20. How deep should you dig when laying WD1 wire under hard-packed dirt roads?
    6 to 12 inches
  21. How deep should you dig WD1 wire in loose or sandy soil?
    At least 3 feet
  22. How much WD1 wire is on a donut roll (MX306)?
    1/2 mile
  23. How much WD1 wire is on a DR8 reel?
    1/4 mile
  24. How far beyond each side of the road should wire be buried?
    At least 2 ft
  25. WD1 wire must be how high above a road crossing?
    At least 18 ft
  26. How much tape should you use when taping a splice?
    At least 4 inches
  27. What device is used to enter FH (Frequency Hop) Data info into the SINCGARS?
    A MX-10579 ECCM Fill Device
  28. What do the letters AN and PRC stand for?
    Army/Navy and Portable Radio Communicator
  29. What is an AN/PRC-68?
    A type of Squad radio small unit transceiver
  30. What is the first thing you do before sending a radio message?
    Listen to see if the Net is clear
  31. What does SINCGARS stand for?
    SINgle Channel Ground/Airborne Radio System
  32. How much does the AN/PRC 77 weigh?
    About 25 lbs
  33. What is the approximate range of the AN/PRC 77?
    5 to 8 KM
  34. How many channels does the AN/PRC 77 have?
    920
  35. What type of knot do you use when repairing WD1 wire?
    A square knot
  36. Most infantry radios are _____ Modulated?
    FM
  37. What does EPLRS Stand for?
    Enhanced Position Location Reporting System

What would you like to do?

Home > Flashcards > Print Preview