Any time personnel are working in or around possible or suspected hazardous/toxic gases or atmospheres
SCBA's shall be worn continuously until
Personnel are removed from the hazardous/toxic gases or atmospheres
All personnel shall recieve training on the correct methods for donning and opperating SCBA's within:
two weeks of being hired and before being placed on shift.
Re-occurring training shall take place through out the year:
as deemed necessary by the training officer and or Shift Captain
What are the seven steps in checking out the multi gas detector?
1. remove from case
2. inspect for physical damage
3. turn unit on in safe well ventilated clean environment
4. let unit warm up for 5 min
5. Oxygen level should read 20.9 and all sensors should read zero
6. perform fresh air calibration
7. turn off unit and replace in case
(if unit does not function properly report deficiency to supervisor and log in daily checkout sheet)
How often will personnel recieve training in use of the multi gas detector?
1. Within 90 days of being hired.
2. Annually by training officer/shift captain
3. Quarterly updates and in-services. (to be signed by shift captains and maintained by training officer)
How long will records be maintained on the multi gas detector useage and maintenace.
define: interior structural firefighting
physical activity of fire suppression inside of a burning building or enclosed structures which are involved in a fire situation beyond the incipient stage
define: Incipient stage
means a fire which is in the initial stage and which can be controlled or extinguished by portable fire extinguisher, class II standpipe or small hose system without the need for protective clothing or breathing apparatus
What is IDLH?
Immediately dangerous to life and health. (any structural fire beyond the incipient stage)
Define: Imminent danger
a hazard that could cause death or serious physical harm immediately, or before the danger can be eliminated through normal enforcement procedures
OSHA's 29 CFR 1910 and 1926 addressed what?
two in/two out
two in/two out shall be applied when?
at any fire that is beyond the incipient stage
Interior attack is to be undertaken only after what?
only after sufficient personnel are assembled consisting of a 2 person attack team using the buddy method, and a RIT of at least 2 members
RIT members must remain
outside the IDLH atmosphere in standby mode.
RIT members must have proper equipment:
readily available to conduct a rescue of the attack team if needed.
A member of the RIT may be incident commander or safety officer true or false?
true. After initial size up if more personnel havent arrived the incident comander will don a SCBA and perform rescue if necessary.
The pump operator may be considered part of the RIT true or false?
False. The pump operator's main responsibility will be to ensure the proper operation of the pump
The pump operator may temporarily assume the role of incident comander true or false?
True. If the incident comander is required to perform rescue as part of the RIT.
True or false. Unlocks will be performed while the vehicle is running.
True. If the vehicle is running in a confined space.
True or false. On days the fire dept is notified of an Ozone Alert hydrant testing will be postponed
The incident commander shall request that the gas company respond to the scene of a carbon monoxide response if the following conditions are met.
1. A CO level of over 9ppm
2. An appliance is turned off by the fire dept
3. Someone is showing signs of being ill due to CO
4. The IC feels the gas company should be notified
For nighttime opperations turn off fire apparatus _______ and ________. This will help reduce the blinding effect to approaching vehicle traffic. Other emergency lighting should be reduced to yellow lights and emergency flashers when possible
headlights, wig wag lights
True or false. When an emt encounters a situation where they cannot arouse anyone at the scene, it is necessary for a police officer to be on scene while forcible entry is being performed.
false. Police will be summoned but are not required to be on scene to begin forcible entry.
Type of priming oil for L-1
Type of primer oil for E-3
Type of priming oil for E-2
Running an engine higher than _____ rpm during priming is not recommended
Never prime a pump longer than _____
Pto must be at less than ______ rpm before being engaged
Four things that influence a fire stream
Velocity Gravity Friction and Wind
How many gallons of water must a apparatus have to be considered a pumer
What does NFPA 1901 cover?
Automotive Fire Apparatus
What is the first tactical priority on all fires?
What do ornamental stars on the outside of building mean?
It shows a building in a deteriorating state
How does one prevent kinks in hose?
two full twists
What is tandem pumping?
two apparatus in a line pumping
What does duel pumping involve?
two apparatus pumping off a hydrant
Atmospheric pressure ________ ____ for every 1000 ft.
decreases .5 psi
What is the pressure loss for master stream devices?
What are the three steps and times for pumper service testing?
100% 150 psi for 20 min
70% 200 psi for 10 min
50% 250 psi for 10 min
List the 12 command responsibilities
A assume effective command
R rapidly evaluated the situation
T transmit brief initial radio report
D develop a plan of attack
A assign units as required
A assume/delegate role of safety officer
A accountability guidelines
P provide continuing command of progress reports
A assign tactical objective
R review and evaluated attack efforts
R request additional units as needed
P provide orderly return to service
If L-1 does not start within ____ sec allow motor to cool for ____ before restarting
15 seconds, 1 minute
Position L-1 aerial device ____ above structure
6 to 12 inches
L-1 aerial must be raised ____ before tilting the cab.
The vertical height of aerial is _____. The horizontal reach is _____.
75 feet, 67.8 feet.
L-1 outriggers are mounted under the frame with a ____ ground clearance.
L-1 aerial sections are base____, mid ____, fly ____
27.7 feet, 27.5 feet, 30.11 feet.
L-1 monitor nozzle has a max vertical travel of ____ and a horizontal travel of ______.
135 degrees, 90 degrees.
Bring L-1aerial to _____ psi to maintain 1000 gpm
L-1 hydrolic system includes the following four items.
L-1 turntableplatform diameter is ____ with a _____ thickness
96 inches, 3/8 inch
L-1 has __________ to supply hydrolic flow to prevent catastrophic malfuctions of engine or hydrolic pump.
dual electric 12 volt pumps
Before pinning L-1 waterway to its alternate position, waterway must be ____ ladder _____ and aerial at ____ elevation.
drained, retracted, 0 degrees.
True or false, never unlock water way pin when L-1 aerial waterway is in use.
Running L-1 engine at higher than _____ rpm during priming is not recommended.
L-1 pump should not be primed longer than ____ seconds
The pump cooler _______ water through a ___ line from the tank to the pump.
recirculates, 1/4 inch.
L-1 is a ______ gpm pumper with a ____ gallon water tank.
Under ideal conditions L-1 master intake should not be below ____