e&e handtools and hardware ure

Card Set Information

e&e handtools and hardware ure
2010-05-19 03:35:28


Show Answers:

  1. a precaution concerning torque wrenches is to
    never use a torque wrench that has been dropped unless it has been verified
  2. when torquing a bolt assembly, what is the force applied to overcome friction?
  3. what type of pliers would you use to bend thin metal or form loops in wire?
    round nose
  4. when filing aluminum or lead, you should use a
  5. which of the following is a true statement concerning a properly ground tip on a standard screwdriver?
    it is square and flat
  6. never use cushioned clamps ina ny bonding or grounding connection, because the cusion acts as
    an insulator
  7. tubbing used in aircraft oxygen, fuel, fire extinguishing, instruments, hydraulic, and vent lines is
    aluminum alloy and stainless steel
  8. the EMP hardened cable provides a barrier to
    electrostatic interference
  9. you can remove a difficult screw with a square-shank screwdriver by applying a
    wrench to the shank
  10. what kind of pliers are mainly for holding or bending flat or round stock?
    combination slip joint
  11. which technical order tells you the appropriate temperature setting for a wire marking machine?
  12. what is the maximum numebr of bolts you can safety wire together in series using the double twist method
  13. what sequence of files would you use to file soft steel?
    start with a second cut, finish with a smooth file
  14. when installing a cotter pin, ensure the prong that bends over the bolt shank does not exceed the bolt
  15. what ensures a connector plug and receptical are not mismated?
    key and key way arrangement
  16. a fixed union between two metallic objects that permits good electrical conductivity between the is
  17. when striking an object with a hammer, the hammer face should be
    parallel to the work
  18. before storing a torque wrench you have used, you should
    set it at its lowest usable setting
  19. how much will thermofit material, used in compact wire bundles, shrink when heat is applied to it?
    one half its original diameter
  20. solderless terminals are preferred over soldered types because
    they are faster, cleaner, and more uniform
  21. how many nicked or broken wire strands are allowed on 16 gauge aliminum wire?
  22. wires and wire bundles should be supported by clampsor gromments at intervals of no more than
    24 inches
  23. after a bonding or grounding jumper is installed it should read no more that
    0.1 ohms
  24. what type of gauge would you use to measure an actuating switch clearance?
  25. all wire groups or bundles must be tied when supports are more than
    12 inches apart
  26. which wrench is usually the strongest, fastest, and safest in a tool kit?
  27. what kind of pliers are good for pullingcotter pins?
    diagnal cutting