Unit 1 Review Exercises

Card Set Information

Author:
crewchiefMichael
ID:
244772
Filename:
Unit 1 Review Exercises
Updated:
2013-11-03 18:13:49
Tags:
Yellow
Folders:

Description:
001 - 006
Show Answers:

Home > Flashcards > Print Preview

The flashcards below were created by user crewchiefMichael on FreezingBlue Flashcards. What would you like to do?


  1. The estimated percent of accidents caused by nature is

    A. 2
    B. 6
    C. 8
    D. 4
    A. 2
    (this multiple choice question has been scrambled)
  2. What is the percentage of accidents attributed to unsafe acts and physical hazards?

    A. 50
    B. 70
    C. 90
    D. 98
    D. 98
    (this multiple choice question has been scrambled)
  3. Which directives are used when performing maintenance procedures?

    A. TOs, handbooks, & CDCs
    B. Manuals, TOs, & handbooks
    C. manuals, CDCs, & handbooks
    D. TOs, manuals, & CDCs
    B. Manuals, TOs, & handbooks
    (this multiple choice question has been scrambled)
  4. What safety training phase is described as an effective tool that creates a lasting impression for new airman?

    A. Initial
    B. General
    C. Supervisor's
    D. Sustained job safety
    A. Initial
    (this multiple choice question has been scrambled)
  5. A chemical must be identified as a carcinogen in the MSDS if concentrations are greater than

    A.  0.1 %
    B. -2.0 %
    C. -1.0 %
    D.  1.0 %
    A.  0.1 %
    (this multiple choice question has been scrambled)
  6. Hazardous Waste Management System rules are published by

    A. each MAJCOM
    B. EPA
    C. the U.S. Air Force
    D. DOD
    B. EPA
    (this multiple choice question has been scrambled)
  7. Temporary storage of hazardous materials at a central accumulation point cannot exceed

    A. 90 days
    B. 30 days
    C. 60 days
    D. 120 days
    A. 90 days
    (this multiple choice question has been scrambled)
  8. What affects radiation hazards?

    A. Time of exposure, amount of training, & number of operating units
    B. Input power, weather, & number of personnel in the area
    C. Strength of emission, time of day, & input power
    D. Strength of emission, time of exposure, & weather
    D. Strength of emission, time of exposure, and weather
    (this multiple choice question has been scrambled)
  9. The recommended procedure for cooling an overheated brake assembly is to park the aircraft in an isolated location and then

    A. cool with forced air from a blower
    B. spray with cold water
    C. allow the assembly to cool in the ambient air
    D. cool with high pressure compressed air
    C. allow the assembly to cool in the ambient air
    (this multiple choice question has been scrambled)
  10. The noise intensity of a jet engine is greatest toward the rear of the engine and to either side at an angle of

    A. 15 degrees
    B. 65 degrees
    C. 45 degrees
    D. 95 degrees
    C. 45 degrees
    (this multiple choice question has been scrambled)
  11. Which symptom is not a sign of noise fatigue?

    A. Impaired mental concentration
    B. Emotional irritablity
    C. Dizziness
    D. A feeling of emptiness
    D. A feeling of emptiness
    (this multiple choice question has been scrambled)
  12. When launching an aircraft containing live ammunition, who is responsible for removing the safety devices associated with these explosive devices?

    A. Flight engineer
    B. Crew chief
    C. Weapons personnel
    D. Only senior personnel on special orders
    C. Weapons personnel
    (this multiple choice question has been scrambled)
  13. Before moving an explosives loaded aircraft into a hangar you must

    A. Install shorting plugs and clips
    B. Remove all ammunition and explosives
    C. Install mechanical safety devices
    D. Position all fire control switches to SAFE or OFF
    D. Position all fire control switches to SAFE or OFF
    (this multiple choice question has been scrambled)
  14. All composite material-related safety training must be documented on which AF IMT form?

    A. 1297
    B. 623
    C. 55
    D. 457
    C. 55
    (this multiple choice question has been scrambled)
  15. The first step in developing an effective FOD prevention program is to

    A. Educate all personnel
    B. Follow MAJCOM guidelines
    C. Identify all possible sources of FOD
    D. Ensure the tool control program is functioning properly
    C. Identify all possible sources of FOD
    (this multiple choice question has been scrambled)
  16. Who is responsible for FOD prevention?

    A. Everyone
    B. Immediate supervisor
    C. Wing commander
    D. Logistics and operations group commander
    A. Everyone
    (this multiple choice question has been scrambled)
  17. When a lost tool cannot be located, the lowest person authorized to clear a red X is the

    A. Group commander
    B. Wing commander
    C. Maintenance OPS officer/Maintenance SUP
    D. Wing vice commander
    C. Maintenance OPS officer/Maintenance SUP
    (this multiple choice question has been scrambled)
  18. In most units, who is responsible for investigating dropped objects?

    A. The flight safety officer
    B. QA
    C. The OPS commander
    D. The FOD prevention office
    B. QA
    (this multiple choice question has been scrambled)
  19. The pressure in a fire extinguisher is within a safe operating range when the gauge needle is within the

    A. Black markings
    B. Orange markings
    C. Red markings
    D. Green markings
    D. Green markings
    (this multiple choice question has been scrambled)
  20. Individuals not directly involved in nitrogen servicing should remain outside a

    A. 25 ft radius
    B. 15 ft radius
    C. 50 ft radius
    D. 20 ft radius
    D. 20 ft radius
    (this multiple choice question has been scrambled)
  21. Who is responsible for the -1 TO preflight check?

    A. Supervision
    B. The aircrew
    C. The ground crew
    D. Operations
    B. The aircrew
    (this multiple choice question has been scrambled)
  22. When serving as fireguard, you position yourself even with the

    A. tail of the aircraft and at a 30 degree angle INBD of the engine being started
    B. nose of the aircraft and at a 45 degree angle OTBD of the engine being started
    C. nose of the aircraft and at a 45 degree angle INBD of the engine being started
    D. tail of the aircraft and at a 30 degree angle OTBD of the engine being started
    B. nose of the aircraft and at a 45 degree angle OTBD of the engine being started
    (this multiple choice question has been scrambled)
  23. What reference covers internationally accepted hand signals?

    A. TO 00-25-212
    B. TO 00-25-172
    C. AFI  23-106
    D. AFI 11-218
    D. AFI 11-218
    (this multiple choice question has been scrambled)
  24. During an aircraft tow, who is authorized to give the "all clear to move" order?

    A. SUP or wing walkers
    B. SUP or brake operator
    C. SUP or vehicle operator
    D. SUP only
    D. SUP only
    (this multiple choice question has been scrambled)

What would you like to do?

Home > Flashcards > Print Preview