ARRL T2A questions valid until June 2014.txt

Card Set Information

Author:
mwinstom
ID:
267345
Filename:
ARRL T2A questions valid until June 2014.txt
Updated:
2014-03-21 11:36:15
Tags:
ARRL
Folders:
ARRL
Description:
ARRL
Show Answers:

Home > Flashcards > Print Preview

The flashcards below were created by user mwinstom on FreezingBlue Flashcards. What would you like to do?


  1. What is the most common repeater frequency offset in the 2 meter band?
    A. plus 500 kHz
    B. plus or minus 600 kHz
    C. minus 500 kHz
    D. Only plus 600 kHz
    B
  2. What is the national calling frequency for FM simplex operations in the 70 cm band?
    A. 146.520 MHz
    B. 145.000 MHz
    C. 432.100 MHz
    D. 446.000 MHz
    D
  3. What is a common repeater frequency offset in the 70 cm band?
    A. Plus or minus 5 MHz
    B. Plus or minus 600 kHz
    C. Minus 600 kHz
    D. Plus 600 kHz
    A
  4. What is an appropriate way to call another station on a repeater if you know the other station's call sign?
    A. Say "break, break" then say the station's call sign
    B. Say the station's call sign then identify with your call sign
    C. Say "CQ" three times then the other station's call sign
    D. Wait for the station to call "CQ" then answer it
    B
  5. What should you transmit when responding to a call of CQ?
    A. CQ followed by the other station’s call sign
    B. Your call sign followed by the other station’s call sign
    C. The other station’s call sign followed by your call sign
    D. A signal report followed by your call sign
    C
  6. What must an amateur operator do when making on-air transmissions to test equipment or antennas?
    A. Properly identify the transmitting station
    B. Make test transmissions only after 10:00 p.m. local time
    C. Notify the FCC of the test transmission
    D. State the purpose of the test during the test procedure
    A
  7. Which of the following is true when making a test transmission?
    A. Station identification is not required if the transmission is less than 15 seconds
    B. Station identification is not required if the transmission is less than 1 watt
    C. Station identification is required only if your station can be heard
    D. Station identification is required at least every ten minutes during the test and at the end
    D
  8. What is the meaning of the procedural signal "CQ"?
    A. Call on the quarter hour
    B. A new antenna is being tested (no station should answer)
    C. Only the called station should transmit
    D. Calling any station
    D
  9. What brief statement is often used in place of "CQ" to indicate that you are listening on a repeater?
    A. Say "Hello test" followed by your call sign
    B. Say your call sign
    C. Say the repeater call sign followed by your call sign
    D. Say the letters "QSY" followed by your call sign
    B
  10. What is a band plan, beyond the privileges established by the FCC?
    A. A voluntary guideline for using different modes or activities within an amateur band
    B. A mandated list of operating schedules
    C. A list of scheduled net frequencies
    D. A plan devised by a club to use a frequency band during a contest
    A
  11. What are the FCC rules regarding power levels used in the amateur bands?
    A. Always use the maximum power allowed to ensure that you complete the contact
    B. An amateur may use no more than 200 watts PEP to make an amateur contact
    C. An amateur may use up to 1500 watts PEP on any amateur frequency
    D. An amateur must use the minimum transmitter power necessary to carry out the desired communication
    D

What would you like to do?

Home > Flashcards > Print Preview