ARRL T2B questions valid until June 2014.txt

The flashcards below were created by user mwinstom on FreezingBlue Flashcards.

  1. What is the term used to describe an amateur station that is transmitting and receiving on the same frequency?
    A. Full duplex communication
    B. Diplex communication
    C. Simplex communication
    D. Half duplex communication
  2. What is the term used to describe the use of a sub-audible tone transmitted with normal voice audio to open the squelch of a receiver?
    A. Carrier squelch
    B. Tone burst
    C. DTMF
    D. CTCSS
  3. Which of the following describes the muting of receiver audio controlled solely by the presence or absence of an RF signal?
    A. Tone squelch
    B. Carrier squelch
    C. CTCSS
    D. Modulated carrier
  4. Which of the following common problems might cause you to be able to hear but not access a repeater even when transmitting with the proper offset?
    A. The repeater receiver requires audio tone burst for access
    B. The repeater receiver requires a CTCSS tone for access
    C. The repeater receiver may require a DCS tone sequence for access
    D. All of these choices are correct
  5. What determines the amount of deviation of an FM signal?
    A. Both the frequency and amplitude of the modulating signal
    B. The frequency of the modulating signal
    C. The amplitude of the modulating signal
    D. The relative phase of the modulating signal and the carrier
  6. What happens when the deviation of an FM transmitter is increased?
    A. Its signal occupies more bandwidth
    B. Its output power increases
    C. Its output power and bandwidth increases
    D. Asymmetric modulation occurs
  7. What should you do if you receive a report that your station’s transmissions are causing splatter or interference on nearby frequencies?
    A. Increase transmit power
    B. Change mode of transmission
    C. Report the interference to the equipment manufacturer
    D. Check your transmitter for off-frequency operation or spurious emissions
  8. What is the proper course of action if your station’s transmission unintentionally interferes with another station?
    A. Rotate your antenna slightly
    B. Properly identify your transmission and move to a different frequency
    C. Increase power
    D. Change antenna polarization
  9. Which of the following methods is encouraged by the FCC when identifying your station when using phone?
    A. Use of a phonetic alphabet
    B. Send your call sign in CW as well as voice
    C. Repeat your call sign three times
    D. Increase your signal to full power when identifying
  10. What is the "Q" signal used to indicate that you are receiving interference from other stations?
    A. QRM
    B. QRN
    C. QTH
    D. QSB
  11. What is the "Q" signal used to indicate that you are changing frequency?
    A. QRU
    B. QSY
    C. QSL
    D. QRZ
Card Set:
ARRL T2B questions valid until June 2014.txt
2014-03-21 15:37:49
Show Answers: