ET2 Performance and Training.txt

Card Set Information

Author:
bc901
ID:
286884
Filename:
ET2 Performance and Training.txt
Updated:
2014-10-24 01:18:08
Tags:
xyz
Folders:

Description:
xyz
Show Answers:

Home > Flashcards > Print Preview

The flashcards below were created by user bc901 on FreezingBlue Flashcards. What would you like to do?


  1. When working within ++++ feet of exposed energized circuits, do not wear metal items, such as:
  2. • Rings
  3. • Watches
  4. • Bracelets
  5. • Dog tags
  6. • Metal-framed eyewear
    four
  7. When working on live electrical circuits of +++volts or more, non-conductive shoes that meet American National Standards Institute (ANSI)-Z41 requirements must be worn.
    30
  8. Shorting probes, rated at ++++ volts, must be located conspicuously in all spaces where electronic equipment is installed.
    25,000
  9. At a minimum, ++++ inch wide 3M electrical insulating tape should be used for sealing the seams.
    four
  10. There are +++ types of matting that are authorized for CG use.
    two
  11. CG authorized rubber matting is rated for no more than ++++ volts
    3000
  12. A labeling plate must be affixed to equipment with more than +++ power source that is +++ volts or more.
    one, 12
  13. The maximum rate of absorption by the human body can occur within the maximum permissible exposure (MPE) limit frequency
  14. range of ++++++
    30 – 300 MHz (VHF band)
  15. Extended exposure at the frequency range of ++++++ is dangerous.
    30 – 300 MHz
  16. For individuals in the occupational/controlled exposure category the averaging RF radiation exposure time limit is +++++ minutes
    six
  17. For individuals in the general population/uncontrolled exposure category the averaging RF radiation exposure time limit is +++++ minutes
    30
  18. When a worker is exposed to a power density limit two times higher than the limit, then the worker must be away from the field for +++ minutes before or after exposure
    3
  19. When a worker is exposed to a power density limit three times higher than the limit, then the worker must be away from the field for +++ minutes before or after exposure
    4
  20. If no shorts are displayed on a cable being tested on a TDR then you have a +++++
    open cable.
  21. Maintenance is needed on an antenna if a megger reading shows a resistance of +++ Megaohms or less.
    200
  22. A resistance of +++ megaohms or less indicates an immediate and urgent need to correct the problem.
    5
  23. Electrical connectors shall be weatherproofed within +++ hours of assembly
    24
  24. Weatherproofed multi-pin connectors should be visually inspected +++++ for signs of deterioration.
    monthly

What would you like to do?

Home > Flashcards > Print Preview