Card Set Information
The floor of controlled airspace at BRT, 4Y3, 4V4, is _____ AGL or _______ MSL.
When issuing a clearance to an aircraft at a location with ATC service, specify the _____ and initial heading.
direction of turn
When it is not included in the SID, specify the _____
In the event of a lost or overdue AC, suspend or restrict IFR traffic for a period of ____ minutes
In the event of two way radio comm failure in VFR conditions, the pilot shall continue the flight under VFR and ______
Land as soon as practicable
If an IFR aircraft refuses to take a delay on the ground and insists on departving VFR, inform the facility/sector of _____
both the pilots intentions and the VFR departure time
The distance that must be maintained from an obstacle until the aircraft reports leaving an altitude above the obstacle is ______ miles
Separate aircraft departing from same or adjacent airports by 1 mile provided radar id is established within 1 mile of the takeoff end and courses will diverge by ____ degrees or more.
Separate aircraft departing the same runway or parallel rnways takeoff courses separated by less than 2500 feet by ____ miles if courses diverge immediately after departure
Authorize simultaneous takeoffs if nonintersecting runways diverge by ____ degrees or more
Issue current touchdown rvr when:
prevailing visibility is 1 mile or less
there is a reportable value of 6000 feet or less.
Issue a both midpoint; and roll out RVR when:
the value of either is less than 2000 and the touchdown RVR is greater than the midpoint or rollout RVR
Which one do you issue?
Tchdown Midpoint Roll out
2400 2200 2000
1600 1800 2000
2000 1800 1600
2500 1600 1400
When is approach information provided to the pilot?
on intial contact, asap, or pilot request
A ____ procedure is published for public use
A _____ procedure is approved by the FAA but is not published for public use
An aircraft is operating on an unpublished route. When may you issue the approach clearance?
When the AC is established on a published route or instrument approach procedure
An _____ is an imaginary point used within ATC as a basis for vectoring aircraft to the final approach course.
Vector an AC to intercept the final approach course at least _____ miles outside the approach gate unless the ceiling is at least ____ above the MVA and reported visibility is at least ____ miles
Assign headings to intercept the final approach course on a track not to exceed:
____ degrees when less than 2 miles from the approach gate
____ degrees when 2 miles or more from the approach gate
The radar controller performing approach control functions is responsible for separation of radar arrivals unless _____ or _____
visual separation is provided by the tower
an LoA authorizes otherwise
When runway centerlines are at least 2500 feet but NO more than 4300 feet apart, what is the minimum radar separation required diaganolly between successive arivals?
When an AC is in the NTZ, primary responsibility for navigation rests with the _____
What instructions must be issued to an AC not established on an approach segment or published route?
An altitude to maintain until established
The minimum separation required during the turn on to final approach course between ac conducting parallel ils approaches with runways separated by at least 2000 feet is ____ feet or _____ miles
Is a VFR AC that was cleared for an instrument approach authorized to conduct a missed approach?
When shall all VFR aircraft that want to conduct practice instrument approaches be advised to maintain VFR?
on initial contact
Under what conditions may an AC be cleared for a contact approach?
the pilot requests it
the reported ground visibility is at least 1SM
published instrument approach procedure
approved separation provided