API 510 Data sheets ( Miscellaneous other)

Card Set Information

Author:
egf4201
ID:
308993
Filename:
API 510 Data sheets ( Miscellaneous other)
Updated:
2015-10-04 15:26:19
Tags:
API 510 Data sheets Miscellaneous other
Folders:
API 510 Data sheets ( Miscellaneous other)
Description:
API 510 Data sheets ( Miscellaneous other)
Show Answers:

Home > Flashcards > Print Preview

The flashcards below were created by user egf4201 on FreezingBlue Flashcards. What would you like to do?


  1. Define- location on a vessel of vessel MAWP
    top
  2. Define- imperfection that exceeds the acceptance criteria
    defect
  3. Define- a flaw that may or may not exceed the acceptance criteria
    imperfection
  4. Design- joint category of a vessel longitudinal weld
    A
  5. design- joint category of a vessel circumferential weld
    B
  6. Design- RT factors representing Full RT
    RT-1, RT-2
  7. Design- RT factors representing spot RT
    RT-3
  8. Design- weld type- butt double weld
    type 1
  9. Design- weld type- butt single welded with backing
    type 2
  10. design- weld type- butt single welded without backing
    type 3
  11. design- vessel service that always requires full RT
    lethal
  12. Design- max set pressure for single relief device on a vessel
    MAWP
  13. design- marking on nameplate indicating vessel was PWHT
    HT
  14. design- marking on a nameplate indicating vessel is in lethal service
    L
  15. design- ASME sect VIII stamp for routine vessels
    U
  16. design- ASME sect VIII stamp for miniature vessels
    UM
  17. design- ASME sect VIII stamp for relief devices
    UV
  18. NDE- number of CML's to obtaing thickness readings during inspection
    representative
  19. NDE- number of nozzles to obtain thickness readings during inspection
    representative
  20. NDE- lead letter used during RT to check for backscatter radiation
    B
  21. NDE- lead letter used during RT to indicate a film-side IQI
    F
  22. NDE- hole size that must be visible in RT when using a hole-type IQI
    2T
  23. NDE- two primary gamma-ray RT sources
    Ir 192, Co 60
  24. RV's- how relief devices should be transported
    upright
  25. RV's- how relief device intervals are determined
    performance
  26. welding- variables needed on WPS
    Essential & Non-Essential
  27. Welding- variables needed on PQR
    essential
  28. Welding- processes that can be used when substituting preheat or controlled deposition welding for a required PWHT
    SMAW, GMAW, GTAW
  29. welding- min taper required for shell welds with mismatch
    3 to 1
  30. weld qualification- the "all-position" test coupon
    6g
  31. weld qualification- rejectable in RT when qualifying a welder
    Crack, LoF, IP
  32. Weld qualification- which welding process can a welder not be qualified by RT
    GMAW-SC
  33. weld qualification- max allowed thickness on a WPS based on the plate thickness (T) of a PQR test coupon
    2T

What would you like to do?

Home > Flashcards > Print Preview